欧美极品jizzhd欧美爆 I www超碰 I 欧美天天爽 I 久久99这里只有是精品6 I 小sao货cao得你舒服吗国产 I 午夜福利影院私人爽 I 中文精品久久久久人妻 I 日本狠狠操 I www久久精品 I 免费看黄色一级片 I 精品国产免费久久久久久桃子图片 I 精品国产毛片 I 日本免费三片在线播放 I 超碰人人在线 I 成年午夜性影院免费观看 I 白浆影院 I 毛片a久久99亚洲欧美毛片 I 精品自拍视频在线观看 I 成人免费毛片东京热 I 看毛片视频 I 2018国产在线 I 亚洲呻吟 I 日本不卡视频一区 I 高清乱码一区二区三区 I 欧美激情在线一区二区 I 日本少妇喷水视频 I 日韩色偷偷 I 欧美 日韩 国产 成人 在线 I 欧美成人午夜免费全部完 I 亚洲综合色在线

The reason for the insufficient suction of stone sucker, I will introduce to you. Because the heat capacity of semiconductor rectifier element is very small, when the rectifier is overloaded, the temperature of the element rises sharply and the diode is burned. Rectifier components will be aging, there will be a degenerative phenomenon, resulting in the output of the electric bed, so that the suction of the vacuum sucker is insufficient. The inductance of the force line device by dry vacuum suction cup is very large, which will produce a large overvoltage at the moment of disconnecting the coil and may break down the rectifier element. The gas consumption of the straight air generator is determined by the diameter of the working nozzle, but it is also related to the working pressure. With the same nozzle diameter, the air consumption increases with the increase of working pressure. The diameter of nozzle is the main basis for selecting vacuum generator. The larger the nozzle diameter, the larger the suction flow and gas consumption, and the lower the vacuum degree: the smaller the nozzle diameter, the smaller the suction flow and gas consumption, but the higher the vacuum degree. To change the tube base, first unscrew the 2 screws (with gaskets) on the side of the manifold base, replace the old manifold base with a new one, and then put the gasket on the screw, pay attention to the screw with equal force.

In vacuum sensor, turn off the vacuum sensor on the side of 2 screws, and remove the vacuum sensor, then twist off vacuum sensor below the four screws (with washer), and then changed into a new vacuum sensor and put on the washer screw on the base of screw, will be in a good vacuum sensor installation back in vacuum, on the last point on the surface of the upper screw again: in silencer, First screw off the straight empty generator surface, remove the muffler, there is a relay pipe connection in the middle, and then remove the muffler below the 2 black nails, replace the old muffler with the new, screw the muffler base screw, install the relay pipe in the middle, and then reinstall the muffler, and then screw on the side screw.